Photothermal microspectroscopy

Photothermal Micro-Spectroscopy (PTMS), alternatively known as PTTF (PhotoThermal Temperature Fluctuation), ^{[1] [2]} is derived from two parent instrumental techniques: infrared spectroscopy and atomic force microscopy (AFM). In one particular type of AFM, known as scanning thermal microscopy (see Scanning probe microscopy#SThM) [1] , the imaging probe is a sub-miniature temperature sensor, which may be a thermocouple or a resistance thermometer. This same type of detector is employed in a PTMS instrument, enabling it to provide AFM/SThM images: however, the chief additional use of PTMS is to yield infrared spectra from sample regions as small as a micron or less, as outlined below.

Additional recommended knowledge

Guide to balance cleaning: 8 simple steps

Daily Sensitivity Test

How to quickly check pipettes?

Technique

The AFM is interfaced with an infrared spectrometer. For work using Fourier transform Infrared spectroscopy (FTIR), the spectrometer is equipped with a conventional blackbody infrared source. A particular region of the sample may first be chosen on the basis of the image obtained using the AFM imaging mode of operation. Then when material at this location absorbs the electromagnetic radiation, heat is generated which diffuses, giving rise to a decaying temperature profile. The thermal probe then detects the photothermal response of this region of the sample. The resultant measured temperature fluctuations provide an interferogram which replaces the interferogram obtained by a conventional FTIR setup, e.g. by direct detection of the radiation transmitted by a sample. The temperature profile can be made sharp by modulating the excitation beam. This results in the generation of thermal waves whose diffusion length is inversely proportional to the root of the modulation frequency. An important advantage of the thermal approach is that it permits to obtain depth-sensitive subsurface information from surface measurement, thanks to the dependence of thermal diffusion length on modulation frequency.

Applications

The two particular features of PTMS that have determined its applications so far are:

(a) spectroscopic mapping may be performed at a spatial resolution well below the diffraction limit of IR radiation, ultimately at a scale of 20-30 nm. In principle, this opens the way to sub-wavelength IR microscopy (see Scanning probe microscopy; Microscopy#Scanning probe microscopy), where the image contrast is to be determined by the thermal response of individual sample regions to particular spectral wavelengths;

(b) in general, no special preparation technique is required when solid samples are to be studied. For most standard FTIR methods, this is not the case.

For examples of applications of PTMS in Biomedical research and polymer science, see ^{[3] [4] [5] [6] [7]}

Related technique

This spectroscopic technique complements another recently-developed method of chemical characterisation or fingerprinting, namely micro-thermal analysis (micro-TA) ^{[8] [9]}. This also uses an “active” SThM probe, which acts as a heater as well as a thermometer, so as to inject evanescent temperature waves into a sample and to allow sub-surface imaging of polymers and other materials. The sub-surface detail detected corresponds to variations in heat capacity or thermal conductivity. Ramping the temperature of the probe, and thus the temperature of the small sample region in contact with it, allows localised thermal analysis and/or thermomechanometry to be performed.

References